[EmmaKite Octopus... help!]

https://www.newmexico.org/event/kite-flying-and-tailgate-picnic/108/

[EmmaKite Octopus... help!]

Not too bad, but as the wind got strong I definitely had to pay attention. Super easy to launch and was so fun to watch flying in the breeze.

[EmmaKite Octopus... help!]

I just wanted to thank everyone for the help and knowledge. I had an amazing kite festival out in NM... it's an annual one in Glenwood that anyone who heads that way in April should check out! I will post a link here it's always the first weekend in April. My Octo was a big hit.

[EmmaKite Octopus... help!]

On 3/9/2018 at 3:13 AM, Chook said:

Yeh to achor my display kites, I remove my tow bar and use the cross retaining pin to anchor my kites. Great if the wind changes direction as I can just reverse the car round.

I pass my line doubled up through the figure of eight back round it like a mountain climber would do to decend, then down to a bottom cleat. I just use the figure of eight reversed as the kite line is much smaller in diameter than dynamic climbing rope it's designed for.

The grey webbing goes into the tow hitch receiver and retained by the original pin. After setting my main lifter kite I can then send my laundry up fully controlled and tie off round the cleats to adjust them independently.   (I cant find the original web site that this setup was detailed on and I copied it from. )

The top setup is for using a tree (see the extra 2800lb webbing retained by the elastic band by the roll of 1000lb line)

I can easily adjust for more height while powered up if needed with my 26mtr Occy. I use 2200lb line on her as we get pretty strong sea breezes that can catch me out if they suddenly gust through.

 

That's quite the setup Chook! Thank you so much for the detailed instructions, and letting me see the pieces of the setup.

I believe I'll take the rebar anchors I have out, plus we'll have a pickup to anchor to if need be. Your Octopus is beautiful! Looks like a real custom and well-made kite.

[EmmaKite Octopus... help!]

On 3/8/2018 at 11:05 PM, Edmond Dragut said:

1000 Lbs or more. strong anchor may be made from a 2 Inch galvanized pipe and grounded at 1 1/2 feet deep angled in counter of the wind. depending of locations you may use a three or if you have a towing hitch an your car. do not count on light winds, at 49 fits long the head is around 8 fits in wind with huge lift power.if the wind is low is fine but at 200-250 fits high may be a different story. use the strongest line all the time to avoid accidents even on apparently low winds and make the anchor count. after line the anchor is second important thing. last year i break a 250 lbs line with a 3 m sled and i lost the kite and 2 35' spinner tails  in Michigan lake 

Oh no losing a big kite like that must be the worst feeling- watching it fly away and disappear! I'm sorry that happened to you... I did order the 500 lb line for this first flight. If it seems to need more, I'll upgrade. Thanks for the tip- I have a good rebar stake we use to anchor big tents at festivals, so I think it will work for this too.

[EmmaKite Octopus... help!]

On 3/8/2018 at 7:36 PM, Kansas Flier said:

My two cents:

You are going to want to anchor this kite. Anchor the kite before you launch it. You will need to choose an anchor that is appropriate for the location.  The Gomberg website has a good article about anchors. There are several Youtube videos demonstrating different anchors.  Walk the kite up, walk the kite back down.

I would suggest your first launch be in lighter winds, 7-12 MPH. Wear gloves. Don't wrap the line around your hand. 

If the kite comes down, there is a chance the kite might self launch if the winds pick up or changes direction. 

The kite might have enough pull to lift some line laundry. 

Need to post some pics once you get it in the air.

I absolutely will take pics! And I plan to anchor for sure. I will be cautious, and don't plan to fly around large groups of people or cows anyway ha ha.. Oh and thank you for the Gomberg link! I hadn't run across their info yet, and got a winder from them as well as reading the anchor article. Appreciate it.

[EmmaKite Octopus... help!]

On 3/8/2018 at 6:44 PM, SparkieRob said:

I've got an 8 meter (25 feet) Occy that I use #150 for. I wouldn't go any lower on mine. Agree with the suggestion of #500 line. Don't mess with the bridle as they are set from factory. UNLESS you have some fairly major issues with it in flight behaviour.

Octopuses look amazing in the sky.

Sent from a Galaxy 8 Far Far Down Under.
 

I ordered the 500 lb line, and will definitely stake it down on its maiden flight. Hoping to get it up this coming weekend! They do look so cool flying, it's what brought me back to kites as an adult. Seeing some of these other beauties airborne.

[EmmaKite Octopus... help!]

1 hour ago, T in WI said:

 

Don’t take the yellow shrink wrap off. Get yourself a piece of 500# line about 18-20 inches long and tie it in a loop. Take the loop and larks head it to the loop on the ends of your bridle line so your knot on the 500# is your anchor point to attach your flying line.

You should be able to use 250# flying line in light winds and 500# for heavier wind.

Best of luck and enjoy the fun!


Sent from my iPhone using KiteLife mobile app

 

Thanks T. It did look like it could be amore permanent piece, was sort of hard to tell. Instructions would have been AWESOME. I will do exactly as you suggest, sounds secure and simple enough.  

Thanks again!! Saving my butt over here...

[EmmaKite Octopus... help!]

1 hour ago, Chook said:

I use 1000lb line on my 50' as it's a nice thickness and not so hard on my gloves, just because that is what I have.

500lb "may do it" as mentioned above. They are great lifters with good pull. I tie it to my 4 wheel drive on a grass paddock as it's easy to do.

To get enough wind to launch it, I really think you are in trouble with only 150lbs. My little 26' Occys snap the lines that come with it in any sort of breeze and needed replacement.

Yeh I put a loop "pigtail" on mine and larks head to it as they do up so tight and I didn't want a carabineer flapping around while retrieving it. (walking it down with a strap with a pulley on the end)

50' Occy

Ha something else I wondered about.... enough wind to launch. You've confirmed it for me, the lighter line is getting returned and I'll get the heavier stuff. So much more info from you nice folks here than anywhere else online

And yours looks amazing flying! The bright colors was definitely a good decision 

[EmmaKite Octopus... help!]

I'm afraid to take it off in case I do something wrong! I have the 150 lb so will try that but likely will upgrade to heavier to be safe. I'm so excited to try this big sucker!

[EmmaKite Octopus... help!]

I read somewhere that this forum was super friendly and helpful, and I can see why!! Thanks so much for the input. So by the sounds of it, under this plastic yellow wrapper should be the end point if all the bridle lines... and then I knot my flying line around it. No swivel or metal parts then?

[EmmaKite Octopus... help!]

Hi I'm a kite newbie except for an Into the Wind Delta I had years ago. I've seen the big octopus kites all over lately, and had to have one.

Now after hours of researching I realize there is very little info out there about how to attach, what kind of line, etc.

I have found videos of how to daisy chain, and the larks head knot.

I bought 150 lb line for my 49 ft octopus. It's a soft airfoil with a complicated looking bridle. Anyone out there have one? Any tips about how to attach to a line? Do I need heavier line? EmmaKites just told me.. no, we don't have instructions. Downside of ordering from China:( Any help appreciated guys!