Jump to content
KiteLife Forum
Sign in to follow this  
Steve Jenkins

Prism Micron Repair Procedure Question

Recommended Posts

I have a Prism Micron with a broken leading edge connector. I ordered replacements and they arrived today. I didn't think it would be very difficult to replace it. However, I'm not sure how to remove the leading edge (.098 carbon rod). On first inspection it appeared that I could just bend it a bit and pop it out of the "pocket" at the back of the wing. I can't seem to get it free though. Am I thinking about this all wrong? Will I just have to use a seam ripper to remove the the stitches at the back of the sail to free it, then sew it back up when completed?

You would think if I can repair a half a million dollar high speed copier that I could handle this. I just thought there might be a correct and incorrect way.

Share this post


Link to post
Share on other sites

I'm not familiar enough with the Micron to be of any help, but hang in there, someone will probably chime in after the holiday.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...