Jump to content
KiteLife Forum

Spectrum Burst


riffclown

After Framing but before adding the permanent stack lines. I just had to see how a burst would look with the set.. Still crazy that all of these came from ONE tail..

**Note, I used a few old SLE Leading Edges to keep the shape while I took the picture.


From the album:

Riffclown's Homemades

· 182 images
  • 182 images
  • 1 comment
  • 109 image comments

Photo Information

  • Taken with samsung SM-G900T
  • Focal Length 4.8 mm
  • Exposure Time 1/60
  • f Aperture f/2.2
  • ISO Speed 40

Recommended Comments

Interesting thought. trying to visualize how the bridling would be accomplished. I'm surd it could be done but the configuration would have to be stabalized.

Link to comment

I did not know what a "burst" was in this context (I think I've figured it out now though). Would I have done so from the start my thoughts would probably have stopped with an image of five people piloting their QLKs and not seen the "arrangement" as a unit (then a SLK). Without the right/standard conclusion, a natural end to a thought, the mind goes on by itself looking for an answer/meaning.

I'm not into kite building, but how about this?: Join the adjacent LE nocks together with short pieces of tubing (>4cm?), that the nocks just fits into, to form the QLK ring. Join the vertical spars together with stubs of tubing (bent to form a small "V") as well. Add a (slight?) V-shape over all to the SLK (or ring of QLK) that is held by crossing spars attached to points close to the nocks using commercially available DLK LE fittings (or short pieces of tubing with a hole in the tubing side wall). Perhaps the crossing spars configuration can be chosen so that the QLK vertical spars are kept close to the QLK ring plane, relieving stress from the joined QLK vertical spar tube connectors when under load from the wind. It is likely that one of the QLK LE segment (for each QLK) would need to be slightly longer to give room for the extra fittings or these fittings would need to propagate into the QLK sails(/LE channels) a few cm. Hopefully the added V-form would add to the kite's stability.

Another variation if you have many QLKs (which seems not to be too uncommon around here). Using "only" (5) 10 more QLKs one could add (one) two more QLK ring(s) by using (two) four double length LE segments. How would that be for a bridling problem?

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...