Bridle problem

[madisonDave]

Hi

I recently purchased a Rev I. When I took it out today for the first time I noticed that the veritical and horizontal parts of the bridle on one side are not tied together (connected). Is this something I can easily fix? If so is there a diagram showing how I should connect these and the steps I need to take.

The sail and spars look fine, it's just one side of the bridle is not connected right near where the end is to connect the flying line (it is near the knot where the larkspur knot goes is where the horizontal and verticle bridle lines are tied together).

Thanks.

David

[REVflyer]

there should be a little loop on the across bridle and a pigtail (where you'd tie on your top flying line) attached to the down bridle leg.

larkshead the loop onto the pigtail, it will form a little hinge area. you want this hinge, but not any bigger than about 3/4 of an inch.

untie the other side and assemble it the same as this one just completed so both sides willl match.